Kidde KN-COPE-D Brochure download pdf (Page 2)

Battery Operated Combination Carbon

Monoxide & Photoelectric Smoke Alarm

Part Number CP9000

Model KN-COPE-D

This alarm uses photoelectric sensing technology. Leading authorities recommend

that both ionization and photoelectric smoke alarms be installed to help insure

maximum detection of the various types of fires that can occur within the home.

Ionization sensing alarms may detect invisible fire particles (associated with fast

flaming fires) sooner than photoelectric alarms. Photoelectric sensing alarms may

detect visible fire particles (associated with slow smoldering fires) sooner than

ionization alarms.

Architectural and Engineering

Specifications

The combination smoke and carbon monoxide alarm shall be Kidde Part Number

CP9000 (Model KN-COPE-D) or approved equal. It shall be powered by one 9V

battery. The temperature operating range shall be between 40°F and 100°F (4°C

and 38°C) and the humidity operating range shall be 10% - 95% relative humid

ity, non condensing.

The unit shall incorporate a photoelectric smoke sensor with nominal sensitivity of

2.5 +/- 0.95%/ft. The CO sensor shall be of a fuel cell design and shall meet the

sensitivity requirements of Underwriters Laboratories UL2034 Single and Multiple

Station Carbon Monoxide Detectors. The unit shall qualify for UL-approved word

ing on the package: “World’s Most Accurate Carbon Monoxide Alarm.”*

The combination alarm can be installed on the surface of any wall or ceiling fol

lowing the UL/NFPA/Manufacturer’s recommended placement guidelines. The unit

shall provide optional tamper resistance that deters removal of the unit from the

wall or ceiling. No additional pieces shall be required to activate this feature.

The alarm shall include a test button that will electronically simulate the pres

ence of smoke and CO and cause the unit to go into both modes of alarm. This

sequence tests the unit’s electronics to ensure proper operation. The CO sensor

will not alarm to levels of CO below 30 ppm and will alarm in the following time

range when exposed to the corresponding levels of CO.

70 ppm CO Concentration 60 – 240 minutes

150 ppm CO Concentration 10 – 50 minutes

400 ppm CO Concentration 4 – 15 minutes

The combination alarm shall have two methods of warning for danger: a piezo

electric horn that is rated at 85 decibels at 10 feet and a voice warning that identi-

fies the danger. For a CO incident, the horn will sound in the repetitive manner

– four (4) fast beeps, a short pause, four (4) fast beeps, a short pause. In between,

the unit will announce “Warning Carbon Monoxide!” After four minutes the

alarm/voice pattern will sound once every minute until the unit is reset, or the

CO eliminated. In a Smoke incident, the horn will sound in the repetitive man

ner – three (3) beeps, a pause, three (3) beeps, a pause. In between, the unit will

announce “Fire! Fire!” The unit shall incorporate 2 LED’s. A green LED will flash

every 30 seconds when in standby condition, every 16 seconds to indicate alarm

memory, and every 2 seconds to indicate the Hush“ mode is active. A red LED will

flash in unison with the sounder pattern. The unit shall include the Smart Hush™

feature that silences the unit for approximately 8 minutes if a nuisance alarm condi

tion occurs. The Green LED on the alarm will flash every 2 seconds while in Smart

Hush™ and will automatically reset itself. Smart Hush™ Feature also provides voice

Technical Specifications

Part Number: CP9000

Model: KN-COPE-D

Power Source:

9V battery

Smoke Sensor: Photoelectric

CO Sensor: Electrochemical

Audio Alarm: 85dB at 10ft

Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)

Humidity Range: 10%-95% relative humidity,

non-condensing

Size: 5.79” in diameter x 1.85” depth

Weight: .7lb

Interconnects: No

Warranty: 10 year limited

1016 Corporate Park Drive

Mebane NC 27302

1-800-880-6788 www.Kidde.com

KL-CP9000 sheet rev. 04-2014

Distributed by:

annunciation of “Hush Mode Activated” when Smart Hush™ is activated

and “Hush Mode Cancelled” when the Hush cycle ends.

The unit shall also indicate a low battery warning utilizing each of the

following methods: a brief alarm chirp, the voice announcement of

“Low Battery!” The unit shall at a minimum meet the requirements of UL

2034, UL217, NFPA72, (chapter 11 2002 edition) The State of California

Fire Marshall, NFPA101 (One and two family dwellings) Federal Housing

Authority (FHA), Housing and Urban Development (HUD). It shall also

include a 10-year manufacturer’s limited warranty.

*Claim approved by UL, based on manufacturer’s reported testing.

Ordering Information

Ordering Pack Pack Dimensions Cartons/

Number UPC I 2 of 5 Config Qty (w x d x h inches) Weight Pallet

21010031 0-47871-10031-6 100-47871-10031-6 CLAM Cut Case (4 Units) 7.9 x 13.2 x 11.7 1.8 54

1 2

Comments to this Manuals

No comments

Kidde KN-COPE-D Brochure Page 2

Comments to this Manuals

Related products and manuals for Carbon monoxide (CO) detectors Kidde KN-COPE-D