Kidde P3010K-CO User Manual download pdf (Page 10)

OPTION 2:

Mounting on Other Surfaces

1. Choose a mounting location (wall or

ceiling) and using the mounting plate

provided as a template, mark three-

hole locations.

2. Install the three provided screws

through the mounting plate and tighten.

DO NOT over-tighten screws. (If

mounting in plasterboard or similar

surface, drill 3/16” holes and use the

plastic anchors provided.) Anchors are

not required for mounting on hard

surfaces such as wood.

ATTACHING AND ACTIVATING THE ALARM

This model is equipped with a feature that automatically activates the alarm

when the alarm is attached to the mounting plate for the first time. Once acti-

vated, the battery will supply power to the alarm for the life of the alarm (10

years) under normal conditions.

Align the alarm with the mounting plate and rotate clockwise (right) approxi-

mately 45° until the unit stops and clicks into place. DO NOT over-tighten. If

unit needs to be re-aligned, rotate the alarm counter clockwise, remove and

rotate to desired alignment. NOTE: The alarm will mount to the plate in three

(3) positions (every 120 degrees).

You will know power has been supplied when alarm briefly chirps. Unit will

remain on until unit is disabled by the user at alarm’s end of life. Do not over

tighten the alarm as damage to alarm or mounting surface may occur.

The alarm is now activated! After installation/activation, test your alarm

as described in Operation and Testing section.

Warning: Failure to properly install and activate this alarm

will prevent proper operation of this alarm and will prevent

its response to fire hazards.

Mounting

Option 2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

No comments

Kidde P3010K-CO User Manual Page 10