Kidde I9070 Brochure download pdf (Page 9)

A missing or improperly installed battery will prevent the battery carrier from

closing and result in improper alarm operation.

This smoke alarm uses a 9V carbon zinc battery (alkaline and lithium batteries

may also be used). A fresh battery should last for one year under normal operat-

ing conditions.

This alarm has a low battery monitor circuit which will cause the alarm to

“chirp” approximately every 30-40 seconds for a minimum of seven (7) days

when the battery gets low. Replace the battery when this condition occurs.

USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE ALARM

REPLACEMENT.

(These batteries are available at many local retail stores).

Carbon-zinc type: EVEREADY 216 OR 1222; GOLD PEAK 1604P OR 1604S

Alkaline type: ENERGIZER 522; DURACELL MN1604 OR MX1604;

GOLD PEAK 1604A PANASONIC 6AM6, 6AM-6, 6AM-6PI,

6AM6X, AND 6LR61 (GA)

Lithium type: ULTRALIFE U9VL-J

NOTE: WEEKLY TESTING IS REQUIRED!

NOTE: IF AFTER BATTERY REPLACEMENT THE ALARM CONTINUES TO

CHIRP, PUSH THE TEST BUTTON. THE HUSH

FEATURE MAY HAVE BEEN

ACTIVATED ACCIDENTLY WHILE CHANGING THE BATTERY AND PUSHING

THE TEST BUTTON WILL END THE HUSH

CYCLE.

WARNING! BE SURE TO FOLLOW BATTERY INSTALLATION INSTRUCTIONS

PRINTED ON THE BACK OF THE ALARM AND USE ONLY THE BATTERIES

SPECIFIED. USE OF DIFFERENT BATTERIES MAY HAVE A DETRIMENTAL

EFFECT ON THE SMOKE ALARM.

PRESS OPEN INSERT

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Kidde I9070 Brochure Page 9