Kidde KN-COSM-IBA User Manual download pdf (Page 18)

Operating Instructions

CAUTION: BEFORE USING THE ALARM HUSH FEATURE,

IDENTIFY THE SOURCE OF THE SMOKE AND BE CERTAIN A

SAFE CONDITION EXISTS.

Reset Feature

If the the Smoke/CO Alarm is sounding a CO alarm, pressing the

test/reset button will silence the alarm.

If the CO condition that caused the alert continues, the alarm will

reactivate within 200 seconds (follow the action plan on page

20).

CO Peak Level Memory

If the green LED is blinking once every 10 seconds, the unit has

detected a hazardous CO condition. If the CO sensor has detected a

CO level of 100 PPM or higher since last reset, it will be recorded by

the Peak Level Memory function. To access the Peak Level Memory

press the test/reset button. If a reading of 100 PPM or higher has

been recorded, the unit will announce “Caution,Carbon Monoxide

Previously Detected.” If you’ve been away from home this feature

allows you to check if there was a CO reading of 100, or higher,

during your absence. Pushing the test/reset button resets the

memory. It’s also reset when the power is removed. Note: the green

LED blinking portion of CO Peak Level Memory is disabled when the

unit is on battery power only.

LED Indicator Operation

Red LED

The red LED will flash as described below under the following

conditions:

--During smoke or CO alarm, with every beep

--During testing (same as alarm)

--Low battery, single flash with chirp

--End of product life, double flash every 30 seconds with chirp

--Unit error mode, single flash with chirp every 30 seconds

--Unit error mode, a Fault Code is flashed every 30 seconds (can

be observed and reported to customer service for

troubleshooting).

2544-7201-01(KN-COSM-IBA)_V2.qxd:_ 2014.5.29 4:35 PM Page 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

No comments

Kidde KN-COSM-IBA User Manual Page 18