Kidde KN-COSM-IBA User Manual download pdf (Page 23)

Alarm Removal

IF TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER

TO TAMPER RESIST FEATURE DESCRIPTION ON PAGE 17 FOR

REMOVAL INSTRUCTIONS.

Remove the alarm from the mounting bracket by rotating the

alarm in the direction of the “OFF” arrow on the cover.

Battery Replacement

If any form of battery failure is detected the red LED light will

flash and the unit will “chirp” one time, followed by the warning

message “LOW BATTERY”. This cycle will occur once every

minute, and will continue for at least seven days. On battery

power, the "LOW BATTERY" voice occurs once every 15 minutes.

If the red LED light flashes along with a chirp every 30

seconds, and is not followed by the voice message “LOW

BATTERY” as described above, and if the green LED flashes

twice per second (AC power only) your unit has

malfunctioned.

Call our toll free Product Support Line at

1-800-880-6788 for instructions on how to return the unit.

BATTERY INSTALLATION AND REMOVAL

To replace or install the batteries slide the battery door in the

direction indicated on the cover of the alarm. When installing

new batteries into the carrier, make sure that the polarity

matches the markings printed on the inside of the battery

compartment, press the battery reminder finger down into the

battery compartment and install the

battery (see Figure 6). Completely

slide the battery door to the

closed position. A missing or

improperly installed battery will

prevent the battery door from

closing and result in improper

alarm operation.

Battery Replacement

SLIDE OPEN

INSERT

FIGURE 6

Battery

finger

2544-7201-01(KN-COSM-IBA)_V2.qxd:_ 2014.5.29 4:35 PM Page 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

No comments

Kidde KN-COSM-IBA User Manual Page 23